|
Item
|
Description |
|
Type |
Standalone type |
|
Interface |
PON |
1000Base-PX20 |
|
LAN |
10/100BaseTx (RJ-45: 4 ports), MDI/MDIX Auto-Negotiation |
|
VoIP |
FXS Interface(RJ-11: 2 ports) |
|
Power Switch |
On/Off |
|
Power(DC) |
DC 12V 1.5A |
|
Reset Switch |
Reset to factory |
|
WPS Switch |
Wi-Fi Protected Setup |
|
ANT |
Fixed Wireless LAN Antenna |
|
Front Panel LED |
Power |
Power On/Off status |
|
PON |
Logical Link status of PON, Loss Of Signal |
|
DATA |
PON Link and Data Transmission status |
|
LAN 1/2/3/4 |
LAN Link and Data Transmission status |
|
VoIP |
VoIP Link and Voice Call status |
|
Wireless |
WLAN Link and Data Transmission status |
|
TEL 1/2 |
VoIP Link and Voice Call Status |
|
Accessories |
UTP Cat.5 Ethernet Cable(RJ-45, Straight)
Power Adaptor (Input - AC: 100 ~ 220V (± 20%))
User Manual |
Network Features
Wire-speed WAN and LAN
Full-duplex Mode WAN and LAN
Auto MDI/MDIX (Medium Dependent Interface Cross) WAN and LAN
IEEE 802.1q VLAN(Tagged, untagged by port) for WAN port
Maximum 16 Active VLAN
VLAN ID range of 1~4094
4K MAC Address
Multicast Features
IGMPv2
IGMPv3
IGMP Snooping
IGMP Join/Leave Suppression
IGMP Fast Leave
IGMP Proxy
32 Multicast Group entry
Multicast throughput: 400M.
Multicast delay < 1.5ms。
Multicast address capacity: no less than 8.
VoIP Features
G.711A/u, G.729, G.723, G.722 etc.
T.38 Fax
Support different signals: dialing tone, ring back tone, etc.
Support SIP
Support MGCP
RTP / RTCP Support RFC 3550 & RFC 3551
Support call waiting
Support call holding
Support call forwarding
Three Party Service
Support caller ID display (Type 1 and 2)
Support DTMF
DHCP Feature
DHCP Client
DHCP Server
In NAT mode, IP will be assigned from the IP Pool of the device, and in Bridge mode, the IP will be assigned from the DHCP server in the network
NAT/NAPT
Selectable between NAT mode and bridge mode
Dynamic/static private IP in NAT mode
Wire-speed for bi-directional packets of more than 256 Byte in NAT/NAPT
Port Forwarding and DMZ Host function
Minimum 500 bi-directional concurrent sessions
QoS Feature
Rate limiting (±10%)
QoS for both upstream and downstream
|
Item |
Detail |
Remark |
|
Classification |
Physical port
802.1p
SRC/DST IP address
TOS/DSCP
TCP/UDP SRC/DST port |
Layer 1, 2, 3, 4 |
|
Marking |
802.1p
DSCP |
Layer 2, 3 |
|
Scheduling |
SPQ |
3 Queues per interface |
Security
Broadcast storm control
MAC filtering
WiFi Features
IEEE 802.11b/g/n
Functional condition
Automatic Fallback
4-level adjustable channel Transmission Output
Manual or automatic selectable channel
Setting and changing of number of CPEs that can access at one time
Mixed use of 802.11b, 802.11g, 802.11n
Encryption (Keys such as Hex, ASCII, special character should be supported)
64/128bit Static WEP Key
WPA
WPA2
WPA-PSK
WPA-PSK2(Option)
4 or more Virtual AP (Multi SSID), and each SSID supports different encryption
SSID should support alphabet, numeric, special character
Hidden SSID
Wireless LAN QoS function: IEEE 802.11e(WMM)
Traffic classification by 802.1p and DSCP field value
IEEE 802.1x
EAP MD5/EAP TTLS
PEAP
RADIUS Client function
TR-069
Session Timeout function.
Upon re-authentication due to Session Timeout, it should be managed by the same Session ID
Idle Timeout
Session Timeout value and Idle Timeout value shall be obtained from Authentication system
Web Redirection upon authentication failure
Session termination upon wireless link down
Account termination transmission function
|
Acct-Terminate-Cause |
Value |
Description |
|
User Request |
1 |
User logoff |
|
Lost Carrier |
2 |
Wireless link down for specific time period |
|
Lost Service |
3 |
When the previous AP sends Acct-stop in roaming mode |
|
Idle Timeout |
4 |
Idle Timeout termination |
|
Session Timeout |
5 |
Session Timeout termination |
|
Admin Reset |
6 |
When admin stops specific Session |
|
Admin Reboot |
7 |
When admin reboots the AP |
Operating & Management
OAM
System or module LED.
SNMP v1, v2 MIB.
Memory structure that allows to save or modify Configuration File
Memory should keep the contents of the memory even when power supply is stopped.
Local and remote Firmware Upgrade (The existing Image should be kept when upgrade fails).
Normal session for system management even when CPU overload
Remote Management
Remote access through Telnet(RFC 854, 855)
CPE Management Server
Device Reset
LAN port reset
Setting and changing Config
Firmware download only through Web Server by TR069
VLAN ID change
MAC Filtering
Time sync through NTP Server
Device status and performance management
Interface Configuration
|
Name |
Spec. |
Description |
|
ON/OFF |
|
Power On / Off |
|
Power Jack DC 5V2A |
|
The input terminal that a power adaptor is connected to. |
|
LAN 1/2/3/4 |
RJ-45 |
Connected through a LAN port UTP cable. |
|
TEL 1/2 |
RJ-11 |
Connected through a FXS port RJ-11 cable. |
|
WiFi |
802.11b/g/n |
Wi-Fi Interface with WPS button (Optional) |
|
Line |
SC/APC |
EPON port (need to be kept clean) | |
ONT C524W
